Facing issues with your SOVE pneumatic actuator? Expand answer Don’t worry! Below are a few simple tips to tackle everyday problems step by step.
Find og udbedring af lækager
If you can see your pneumatic actuator is not functioning properly then it might be leaking. A leak can cause actuator power failure; therefore, it will not operate properly. You can use something simple to find a leak — soapy water! Take some soap, add it to water, and spray it on the air pipes of the actuator. Detection of a leak is by bubbles appearing. Once you discover the location of the leak you can replace damaged components such as seals or o-rings.
You should also inspect the other parts of the actuator for wear. This entails searching for any areas that seem old or broken. Inspecting these sections can help you prevent any more leaks from occuring and maintain your actuator working properly.
Dealing with Sticking Valves
Sometimes a sticking valve might be the case and this will actually cause your pneumatic actuator not to work at all. Stuck valve that is inconvenient to face, but you can understand what happened, so simple initial in troubleshooting. And the first place that you should check is with the valve connections itself. Be cautious that it is open or not appropriate method. If the valve is dirty, wipe it down with a soft cloth or rag.
Another thing you can try is giving that valve a cleaning; if it's still stucky, you may just need a new valve. Safety always comes first, remember that! Always switch off the air supply, before performing any work on the valve. In this way, you will not get hurt while solving the issue.
How to Ensure Your Actuator Works Properly
Proper maintenance is integral to ensuring that your SOVE pneumatic actuator works as it should. Keep the actuator clean, and apply a thin coat of oil regularly to keep rust at bay and ensure minimal wear. Rust: Rust is just like a stain which can destroy the metal. Wear: Wear is when a part gets bad and not in a good condition.
Examine the air lines and fittings as well for damage or wear. If you see something worn or loosening up, tighten the connections. Also be sure to always adhere to the manufacturer schedule for maintenance. This will help to prevent unnecessary damage to the actuator and subsequently make it functional for more time.
Inspection of Control Systems and Wiring
Now, control systems and wiring are a major section of your pneumatic actuator and they too can create some issues. Your first step when looking for why they may not be working is to check the wiring connections. Make sure the wires and other components are connected accordingly. If it seems like everything is working okay, but you are still having issues, you may need the entire control system and wiring replaced.
Same thing, air supply should always be turned OFF when wiring. This small step will protect you from danger and avoid accidents when talking about repairs.
Getting Damaged from Too Much Pressure
But the one great enemy that can destroy your SOVE pneumatic actuator is over pressure. Excessive pressure and impact shocks can damage the actuator. The remedy for this is to ensure the correct air pressure and torque are being used in the emissivity actuator during actuating; Torque settings are the guidelines for the tightness of connections.
We should also verify actuator limits to confirm that we are exporting adequate load from under the actuator gym. At this point, if you see wear or something does not feel right, immediately turn off the air feed. If you are ever unsure of how to solve the issue, the best course of action is to contact a professional.